175RC
175RC RB10 "Ti-Look" Lower Arm Studs (Black) (2)
Part # 175-181715.0(1)
Where to buy
$5.49
Prices are as last seen at the store; stock is not tracked.
About this part
175RC RB10 "Ti-Look" Lower Arm Stud Kit. This option gives your ride the Factory Titanium look, without the factory price tag. They're also helpful in increasing strength in your rear arms because you are not repeatedly threading a screw in and out when removing your shocks. Available in multiple colors to best match your build.
Includes:
- (2) 3mm Aluminum Flanged Locknuts
- (2) 3mm Stainless Studs with 1.5mm Hex
- (1) 8mm Depth Setter
Note: Use included 3x8mm screw to pre-thread hole in arm approximately 8mm deep.
Reviews5.0 · 1 review
Stephen JVerified owneron 175RC RB10 "Ti-Look" Lower Arm Studs (Black) (2)
Quick and easy install to make taking the rear shocks off much easier and prevent stripping out the mounting hole in the suspension arm. One tip I have is to use some thread locker (even though it's going into plastic) to keep the whole stud from coming out if I remove the nut. With that said, I never tested it without the thread locker and the surface area inside the suspension arm probably would have held it just fine.
Builds using this part
No builds use this part yet — add it to yours from the build editor.