Parts/Hardware & consumables/Adhesives/Bob Smith Industries UN-CURE CA Debonder (1oz)
Bob Smith Industries UN-CURE CA Debonder (1oz)
Bob Smith Industries

Bob Smith Industries UN-CURE CA Debonder (1oz)

Part # BSI1613.7(3)
Where to buy
$4.99
AMain Hobbies
Seen Oct 12, 2026
$4.99Buy
Prices are as last seen at the store; stock is not tracked.

About this part

This is a one ounce bottle of Bob Smith Industries UN-CURE™ CA Debonder. UN-CURE™ Debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water.

Reviews3.7 · 3 reviews

AnonymousVerified owneron Bob Smith Industries UN-CURE CA Debonder (1oz)

I had been using Losi debonder for about a year and decided to try this as a cheap alternative. It works almost instantaneously. I worked four tires in five minutes compared to the hour or two using the Losi stuff. Just don't get it in a cut. Highly recommended!

2 found this helpful
AnonymousVerified owneron Bob Smith Industries UN-CURE CA Debonder (1oz)

I tried this stuff to debond tires and it took a hole bottle and 4 days to debond 1 tire. I thought this stuff was complete waste of time and money.

1 found this helpful
Cliff GriffinVerified owneron Bob Smith Industries UN-CURE CA Debonder (1oz)

This stuff is great. I accidently glued a pair of steel scissors together. I ran some of this down the edges of the blades and let it sit for about 15 minutes. They came apart and I just had to wipe them off. Handy stuff to have around.

What reviewers say

Reviewers are divided on the Bob Smith Industries UN-CURE CA Debonder (1oz). One verified owner, who switched from a Losi debonder, reports it worked almost instantly on tires and debonded four in five minutes, cautioning against getting it in a cut. Another verified owner reports it took a whole bottle and four days to debond a single tire and considered it a waste. A third verified owner used it successfully to separate glued steel scissors after about 15 minutes. The sample is small, and the tire-debonding results conflict sharply.

  • + Fast debonding on tires
  • + Works on glued metal parts
  • + Cheaper alternative to Losi debonder
  • − Inconsistent results on tires
  • − Slow for one reviewer, taking days
  • − Caution needed to avoid getting it in cuts
Summary generated from the reviews above.

Builds using this part

No builds use this part yet — add it to yours from the build editor.