CRC
CRC 7mm Shim Set (20)
Part # CLN47375.0(2)
Where to buy
$10.99
Prices are as last seen at the store; stock is not tracked.
About this part
This is a pack of twenty replacement CRC 7mm Shims, and are intended for use with the CRC Gen-X family of cars.
Reviews5.0 · 2 reviews
KaldenVerified owneron CRC 7mm Shim Set (20)
These fit on your SCX10 ii ring gear bearing to properly shim side to side movement. I find moving the ring gear to the furthermost position reference to the pinion gave me the smoothest operation. As the ring and pinion bed in you may have to revisit the shimming for best gear longevity. Most stock rings don't need shimming but as the ring wear in the pinion to ring gap will increase to the point where the force allows the pinion to move the ring away causing the tooth to skip possibly damaging the gear.
1 found this helpful
George WillisVerified owneron CRC 7mm Shim Set (20)
Shims are fine. You get (20) per pack. Thickness as measured by my micrometer is 0.16 mm. Bought these to shim my SCX10iii axle ring and pinions. Didn't end up using them. Just shimmed the pinion with 0.2mm of 5mm shims.
Builds using this part
No builds use this part yet — add it to yours from the build editor.