Custom Works Outlaw 3/Rocket 3 Front Hex Conversion Kit

Read the other review and ordered. Can confirm that the these will fit on the older SC10 as well to adapt to the newer 12mm hubs. Shaved a little off the width and rounded the corner on the bottom of the knuckle to let it fit with stock SC10/T4 arms. Did need to mount the steering pivot ball on top of the hub vs under as shown in the included instructions to eliminate bump steer. 10/10 would recommend to any older Team Associated T4/SC10 owner. Made my old truck drivable again.

I used this to convert the front end of an Associated RC10T4 to hexes. I had to do a little bit of dremmel work to the front arms. It works great. I used 7mm hexes on the rear to complete the project.