Parts/Batteries & charging/LiPo batteries/Fantom Pro Series MSV 5.0 2S Graphene LiHV 150C Battery (7.6V/10000mAh) w/5mm Bullets
Fantom Pro Series MSV 5.0 2S Graphene LiHV 150C Battery (7.6V/10000mAh) w/5mm Bullets
Fantom

Fantom Pro Series MSV 5.0 2S Graphene LiHV 150C Battery (7.6V/10000mAh) w/5mm Bullets

Part # FAN26ST10000
Where to buy
$114.99
AMain Hobbies
Seen Oct 12, 2026
$114.99Buy
Prices are as last seen at the store; stock is not tracked.

About this part

Battery Overview:

The Fantom Pro Series MSV 5.0 2S Graphene LiHV 150C Battery delivers next-generation performance with a focus on consistent power delivery and race-ready reliability. This battery is designed for 2S applications requiring stable voltage, low internal resistance, and efficient energy output throughout the full discharge cycle.

About the Pro Series MSV 5.0


Graphene LiHV Power

The MSV 5.0 series uses advanced graphene LiHV chemistry to maintain higher sustained voltage under load, producing a flatter discharge curve and improved throttle response from start to finish. Its 150C discharge rating supports demanding setups by minimizing voltage sag and improving overall efficiency during high-current draw. Engineered for competitive use, this pack prioritizes predictable power delivery, reduced internal resistance, and stable performance under race conditions for consistent lap-to-lap output.

Features:

  • Lower internal resistance for improved efficiency
  • Higher sustained voltage under load
  • Flatter discharge curve for consistent output
  • Graphene LiHV chemistry for stable performance
  • 150C discharge rating supports high-current demand
  • Crisp throttle response from start to finish
  • Predictable power delivery under race conditions

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

  • DO NOT leave a battery in your model when charging
  • DO NOT leave lithium batteries unattended when charging
  • ALWAYS balance charge lithium battery
  • ALWAYS use a LiPo Safe charging bag/box
  • YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
  • YOU MUST not over discharge lithium battery packs
  • READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.

Includes:

  • (1) Pro Series MSV 5.0 2S Graphene LiHV ULCG 160C Battery (7.6V/10000mAh)

Specifications

Nominal Voltage: 7.6V (2S)
Capacity: 10,000mAh
Maximum Charge Rate: -
Discharge Rates
Continuous: -
Peak: 150C
Cell Configuration: -
Watt Hours: 76Wh
ROAR Approved: Yes
Connectors
Battery: 5mm Bullet
Balance: 2mm Bullet
Dimensions (LxWxH): 5.43x1.85x0.99in (138x47x25.1mm)
Weight: 11.64oz (330g)
CA Residents Prop 65 Warning WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...

Reviews

No reviews yet.

Builds using this part

No builds use this part yet — add it to yours from the build editor.