Hitec HS-82MG Micro Metal Gear Servo
About this part
Specifications:
- Speed:
- 4.8V: 0.12 sec/60 deg.
- 6.0V: 0.1 sec/60 deg.
- Torque:
- 4.8V: 39 oz/in
- 6.0V: 47 oz/in
- Length: 1.17in (29.72mm)
- Width: 0.47in (11.94mm)
- Height: 1.16in (29.46mm)
- Weight: 0.66oz (18.7g)
Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC., defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product.
Reviews5.0 · 3 reviews
Turns out my traxxas rc with 2.4 radio only works with digital servos, this won't work for me.
Was looking for a quality micro servo to use for a dig servo in my Losi Comp Crawler. A friend of mine suggested this one as he uses the same one in his. As with any dig servo, setting end points is critical to keep from cooking the servo. This servo delivers. Great speed and power for a micro. Perfect for the job.
Excelent! Highly recommended! Works very well and are very strong enough!
Three reviews, all rated 5/5. Two reviewers, one a verified owner, describe good performance: one uses it as a digital servo in a Losi Comp Crawler and reports good speed and power for a micro servo, and the other calls it strong and effective. The first reviewer, a verified owner, says it did not suit their Traxxas 2.4 radio because that radio only works with digital servos. The reviews note that endpoints must be set carefully to avoid damaging the servo. The sample is small, and compatibility with radio systems is reported only by one reviewer.
- + Good speed and power for a micro servo
- + Strong for its size
- + Suited to a Losi Comp Crawler build
- − Reported incompatible with a Traxxas 2.4 radio by one reviewer
- − Endpoints must be set carefully to avoid damaging the servo