Hobbywing RPM Sensor
About this part
This Hobbywing RPM Sensor is included as standard equipment with the Platinum-120A-HV, Platinum-70A-HV, FlyFun-100A-HV and FlyFun-80A-HV ESC's. The Hobbywing RPM sensor is compatible with any firmware of the above ESC's, that means if you use Hobbywing RPM sensor, the above ESC's are always compatible with V-Bar governor function.
NOTE: Hobbywing FlyFun-100A-HV (also called Fentium-100A-HV) and FlyFun-80A-HV (also called Fentium-80A-HV) ESC are not upgradable, so they are not compatible with V-Bar governor function unless you use Hobbywing’s own phase sensor.
Reviews5.0 · 1 review
This was smaller than I expected, which was good because I used it for a Lynx Oxy 2 heli using a micro iKon2/Brain 2 FBL. The leads were plenty long for my application. If I cared I would go back and trim the leads. I did need to purchase an adapter since my FBL used smaller ports than the usual JR style. You install this by soldering or otherwise connecting the two exposed wires to any two motor wires.