Holmes Hobbies Puller Pro V2 540 Waterproof Sensored Crawler Motor (2700kV)
About this part
Improvements from v1 include better drag brake, adjustable and more accurate sensors, better performance in reverse rotation rigs, beefier solder tabs for lower resistance, and a sideways oriented sensor port for tight installs.
Features:
- Four pole 18mm diameter x 25mm length rotor
- Twelve slot stator
- 13g phase wires with 4mm bullets installed
- Oversized bearings
- Sensored with adjustable timing
- Waterproof sensor board
- Includes sensor wire
Size: Standard 540
Mounting Pattern: 25mm
Mounting Screws: M3
Shaft Diameter: 3.175mm
Can Diameter: 36mm
Can Length: 53mm
Weight: 210g (7.4oz) with wires
RPM: 50,000 rpm max
Reviews4.0 · 4 reviews
what can you say, its a Holmes Hobbies product. I run this with a mamba x on 4S on the VS410. No need for a 2 speed. The power is great and takes 4s like champ...
Absolutely love this have one in my TRX4 and my axial wraith 1.9
Best motor for any crawler that gets run hard and abused. Its my # 1 pick for a trx4 crawler
I don’t know if I received a messed up motor cause it barely turns and it locks ! Will be returning Chinese crap!
Reviewers largely praise the Holmes Hobbies Puller Pro V2 540 2700kV sensored crawler motor for power and durability, with two verified-style positive reports citing use in TRX4 and Axial Wraith builds, one of them running it on 4S with a Mamba X. One reviewer rated it 1/5, reporting that the motor barely turns and locks up, and suspected a defective unit before returning it. The sample is small and the single negative review describes a possible faulty unit rather than a design issue, so the overall picture is based on limited feedback.
- + Strong power output
- + Durable under hard use
- + Works well in TRX4 crawlers
- + Handles 4S setups
- − Reported defective unit that barely turns and locks
- − Single negative review on reliability