Hot Racing
Hot Racing Arrma Nero Steel CV Slider Drive Shaft Set (2)
Part # HRANRO288E025.0(1)
Where to buy
$48.88
Prices are as last seen at the store; stock is not tracked.
About this part
The Hot Racing Arrma Nero Steel CV Slider Drive Shaft Set can be used in the front or rear position on Arrma Fazon BLX or Nero BLX models.
Features:
Travel: 22mm
Overall collapsed length: 171mm
Overall extended length: 193mm
Wheel pin to outdrive pin collapsed length: 155mm
Wheel pin to outdrive pin extended length: 177mm
Includes:
Features:
- Heavy duty CNC machined #45 hardened carbon steel construction
- Replaces factory front or rear drive axles
- Red anodized aluminum pin capture rings with rubber o-rings to prevent movement
- Design eliminates CV pin setscrew
- Steel is finished black
Travel: 22mm
Overall collapsed length: 171mm
Overall extended length: 193mm
Wheel pin to outdrive pin collapsed length: 155mm
Wheel pin to outdrive pin extended length: 177mm
Includes:
- (2) axle assemblies
- (2) M4x2.5x13.5mm screw pins
- (2) M4x4mm set screws
- Need to Re-use the stock Drive pin and set screw
- Recommended to maintain CV joint and shaft spline with grease
- Recommended to use a removable-type locking adhesive on screws threading into/onto metal
Reviews5.0 · 1 review
Daniel RogersVerified owneron Hot Racing Arrma Nero Steel CV Slider Drive Shaft Set (2)
These are great, was working on something else, but I bought an extra set, but I noticed these had the same locking collar that is on the HR rear drive shaft for the Yeti XL and it is roughly the same length (fits perfectly), and uses the exact same cv parts barrels and pins (you only have to use the 2 ends; the gear that goes into the rear axle housing, and the other end that attaches to the outdrive of the transmission). So, it works as a beefier rear drive axle in the Yeti XL.
1 found this helpful
Builds using this part
No builds use this part yet — add it to yours from the build editor.