Parts/Drivetrain/Driveshafts & CVDs/Hot Racing Axial SCX10 II Heavy Duty Steel Scale Look U-Joints Shafts
Hot Racing
Hot Racing Axial SCX10 II Heavy Duty Steel Scale Look U-Joints Shafts
Part # HRASCXT37A022.5(2)
Fits
Where to buy
$38.88
Prices are as last seen at the store; stock is not tracked.
About this part
Hot Racing Axial SCX10 II Heavy Duty Steel Scale Look U-Joints Shafts are a heavy duty steel driveshaft option for the Axial SCX10 II Kit vehicles (not RTR). These shafts feature a red anodized aluminum cross pin ring to enhance the scale look of the shafts.
Features:
Short shaft compressed length: 61.5mm joint-joint, 90mm overall
Short shaft extended length: 84mm joint-joint, 112.5mm overall
Short shaft travel: ~22mm
Long shaft compressed length: 108mm joint-joint, 136.5mm overall
Long shaft extended length: 130mm joint-joint, 158.5mm overall
Long shaft travel: ~22mm
Outside diameter: 11.5mm
Shaft diameter: 5mm
Features:
- Heavy duty CNC machined hardened carbon steel construction
- 6061 aluminum screw-on sleeves to capture steel telescoping pins
- Red anodized aluminum cross-pin ring enhances scale look
- Replaces factory plastic front and rear drive shafts
- Couplers fit 5mm shafts
- Will NOT work with SCX II vehicles equipped with the 3 gear/RTR transmission
- Must maintain telescoping assembly with grease
Short shaft compressed length: 61.5mm joint-joint, 90mm overall
Short shaft extended length: 84mm joint-joint, 112.5mm overall
Short shaft travel: ~22mm
Long shaft compressed length: 108mm joint-joint, 136.5mm overall
Long shaft extended length: 130mm joint-joint, 158.5mm overall
Long shaft travel: ~22mm
Outside diameter: 11.5mm
Shaft diameter: 5mm
Reviews2.5 · 2 reviews
Carlos HernandezVerified owneron Hot Racing Axial SCX10 II Heavy Duty Steel Scale Look U-Joints Shafts
Item description is incorrect. Says it'll fit a scx10 ii, and it does not, the front is too short and the long is too long. I tried fitting them to a stock scx10 ii honcho.
1 found this helpful
Darrell HolmesVerified owneron Hot Racing Axial SCX10 II Heavy Duty Steel Scale Look U-Joints Shafts
Do not use with aftermarket 2-speed scale transmission builds. It will not allow the front axle to have any travel.
Builds using this part
No builds use this part yet — add it to yours from the build editor.