Hudy 1/8 Off-Road & Truggy Plastic Set-Up Board Decal (449x562mm)
About this part
Reviews3.0 · 4 reviews
I'm very disappointed in this item! The ink bleeds through and the adhesive is worthless! I prepped all surfaces and used a heat gun causesly, and still ended up with a terrible end result
I attached this to a 1/8 sheet of plexiglas and was able to trim off extra up to setup board decal. Makes setting up Typhon 6s TLR buggy so much easier and faster plus you can get much more precise with these. Another plus is I didn't have to spend a couple hundred dollars on a pro setup board.
It doesn't stick well to setup board and comes off on the corners easily.
Just like all of Hudy's products, this setup board guide is great. I have it centered on one of my workbenches so I can use it to tune and setup my truggy right on the table, and I have the 1/10ths scale off-road and the lightweight setup board as part of my track day carry. I'd definitely buy this again!
Reviewers are split on this 1/8 off-road and truggy setup board decal. Two reviewers rate it highly, praising its usefulness for setting up a Typhon 6S TLR buggy and truggy on a workbench, and its value compared with a professional setup board. Two reviewers rate it poorly, reporting that the adhesive does not stick well, lifts at the corners, and that ink bleeds through even after careful surface preparation and heat-gun application. Adhesion and corner lifting appear as the recurring problem in the negative reviews. The sample is small, and the reviews do not establish how consistent adhesion is across application methods or surfaces.
- + Useful for setting up buggies and truggies
- + Good value compared with professional setup boards
- + Easy to trim to size on plexiglas
- − Adhesive does not hold well
- − Corners lift and peel off
- − Ink bleeds through