M2C 40mm 3 Shoe Clutch System for Traxxas Revo/Slayer
About this part
NOTE: A M2C Clutch tool is strongly recommended to assist in the installation and removal of the clutch springs (M2C9500).
Includes:
- (1) 3 Shoe Flywheel
- (1) 7075 Clutch Shoe Set
- (1) .9 Spring Set
- (1) .95 Spring Set
- (1) 1.0 Spring Set (maximum spring size shoes will accept)
- (1) Modified 7mm x 1 Clutch Nut
Reviews4.7 · 3 reviews
Run these on my revo with an rb 523tm and a modified kyosho bumptstart box. Works great.
Nice high quality parts, but just note that it won't fit if you have the OS 11KR carb on your revo. The flywheel hits the carb. Going to order the 36mm flywheel from M2C to see if that will fit.
Works great with os 21tm engine and taxxas clutch bell the only issue I have with it is after around a gallon the shoes have already worn down noticeably however they still seem to work fine.
Reviewers generally report that the M2C 40mm 3 Shoe Clutch System works well on Traxxas Revo/Slayer setups, with one reviewer noting it runs with an RB 523TM engine and a modified Kyosho box, and another with an OS 21TM engine and Traxxas clutch bell. One reviewer describes the parts as high quality. A recurring caveat is fitment: one owner found the flywheel contacts an OS 11KR carburettor on the Revo and said they would try the 36mm flywheel instead. Another reported noticeable shoe wear after about a gallon of fuel, though the shoes still functioned. Three reviews is a small sample.
- + Works well on Revo/Slayer setups
- + High quality parts
- + Performs with multiple engine types reported
- − Flywheel can hit OS 11KR carburettor on Revo
- − Shoes show noticeable wear after about a gallon