MJX HYPER GO 2S Hardcase LiPo Battery (7.4V/1500mAh) w/T-Style Connector

Budget-Friendly 2S LiPo Battery Pack

The MJX HYPER GO 2S Hardcase LiPo Battery is a replacement pack designed for the MJX HYPER GO MEW4 platforms. This 7.4 volt battery features a rugged hardcase that protects against damage from bumps, drops, and harsh terrain, making it ideal for intense off-road bashing. With a 1500mAh capacity, it deliver a solid balance of runtime and power output.

Features:

• 7.4V 2S LiPo battery with 1500mAh capacity
• Rugged hardcase design for maximum protection
• Built for demanding off-road use
• T-style connector for secure and efficient power delivery
• Ideal for intense bashing and rough terrain

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.