Motiv
Motiv LAUNCH PRO Drag Racing Modified Brushless Motor (2.5T)
Part # MOV20925P4.0(2)
Where to buy
$79.19
Prices are as last seen at the store; stock is not tracked.
About this part
The Motiv 2.5 Turn LAUNCH PRO Drag Racing Modified Brushless Motor is a 3 phase, 2 pole motor developed specifically for drag racing. Every MOTIV Motor is hand checked, assembled and packaged by a professional in house at their WI, USA office. During this process, every motor component must meet MOTIV requirements before assembly and packaging. Included is a specification check list which is filled out on a motor to motor basis all through the testing and assembly process to ensure the quality of the finished product.
Features:
- Stator:
- Specially selected stator material for low power loss
- High quality pure copper wire
- Emphasis on hand winding for consistency
- Solder Tabs:
- Gold plated pure copper tabs for low resistance
- Internal "Drop Connection" design to ensure low resistance and consistent internal solder joints
- Rotor:
- Sintered rotor
- High quality neodymium magnet material for lasting magnetism
- Can Assembly:
- High flow vent holes to allow air flow in and out for lower operating temps
- Machined all aluminum anodized can, front plate and end bell
- Infinitely adjustable timing
- Dual precision ball bearings
- Overall:
- Every motor tested in house during the assembly and packaging process
- Spec/test sheet provided uniquely for every motor to ensure quality
- Designed to comply with ROAR specifications
- Lightweight completed design
- Packaged in reusable cushioned storage container
Reviews4.0 · 2 reviews
arnaldo r collazo oliverasVerified owneron Motiv LAUNCH PRO Drag Racing Modified Brushless Motor (2.5T)
The timing on this motor is off I tested motor with 2 different motor analyzer motor on 50° both analyzer say motor is on 33°
Jonathan RansomVerified owneron Motiv LAUNCH PRO Drag Racing Modified Brushless Motor (2.5T)
The best in the game llllllllllllllllllllllllllllllll????
Builds using this part
No builds use this part yet — add it to yours from the build editor.