Muchmore Impact 4S FD4 LiPo Battery 130C (14.8V/6500mAh) w/XT90 Connector

Impact 4S FD4 Battery Overview:

The Impact 4S FD4 LiPo Battery Pack from Muchmore is designed to deliver top-notch performance and reliability for 1/8 electric buggies and truggies. With a robust capacity of 6500mAh and a high C-rate of 130C, this battery pack ensures your RC vehicles have the power they need for extended runs and intense competitions. Encased in a durable hard case, this battery not only offers superior energy output but also enhanced safety, making it a preferred choice for RC enthusiasts.

Features:

• 130C discharge rate
• Hard case for added safety
• High-quality 10AWG silicone wire
• Ideal for 1/8 electric buggies and truggies

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.