Parts/Radio & control/Servo horns & arms/ProTek RC Dual Offset Heavy Duty Clamping Servo Horn (Standard) (25T)

About this part

The ProTek R/C Dual Offset Heavy Duty Clamping Servo Horn features a dual offset allowing you to choose the best offset for your setup. The 4mm thick horn has a 20mm and 16mm hole spacing threaded for 3mm hardware to suit the geometry and hardware requirements of most vehicles. Package includes one standard length servo horn, one 3x10mm button head screw and one 2x7.5mm clamp screw.

Features:
  • Clamp design
  • 20mm & 16.0mm hole spacing (measured from output shaft screw hole, to linkage rod holes, center to center)
  • 4.0mm thick arm
  • 33mm Overall End to End length
  • Linkage holes threaded for 3mm hardware
  • 25T Spline Futaba/Savox/ProTek Output Shaft
  • Unique Mounting Screw: PTK-H-1218
CA Residents Prop 65 Warning WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...

Reviews5.0 · 1 review

Michael WebbVerified owneron ProTek RC Dual Offset Heavy Duty Clamping Servo Horn (Standard) (25T)

I have been running these in our ebuggy and etruggy with no issues. Very well made and look great.

1 found this helpful

Builds using this part

No builds use this part yet — add it to yours from the build editor.