ProTek RC Universal Chassis Protective Sheet (Pink) (2) (12.5x33.5cm)
About this part
The ProTek RC Universal Uncut "Thick" Chassis Protective Sheet is 12.5cm wide by 33.5cm long and designed for universal use. This protective sheet is made from thick laminate and backed by an aggressive adhesive vinyl.
Protective sheets are highly recommended for use on new and used chassis to resist against scratches and scrapes and prolong the life of the chassis. For best results, always replace the sheet when noticeable wear occurs.
In addition to protecting the chassis, this sheet also provides a slick and smooth chassis surface which reduces friction when contacting the race surface - especially clay! If you happen to land hard and bottom out, your buggy should more easily slide through it and maintain momentum.
Features:
- Made from genuine 3M® material
- Thick long lasting laminate
- Protects against scratches and wear
- Keeps chassis looking new
- Uncut for universal use
- Made in the USA
- 12.5cm (4.9") wide x 33.5cm (13.2") long
- Available in a variety of colors
- Includes two sheets
CA Residents Prop 65 Warning
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...Reviews4.3 · 3 reviews
Normally I use a roll of vinyl made for vinyl cutters but went with these when I saw they bright color and figured why not. They are about 3 times thicker than the cheap stuff I use. Obviously the cost is a good bit more but I've beat the hell out of it and it hasn't broken through the material yet. Much higher levels of protection than the thin stuff.
This is a decent product. It’s tough and it glides well over rough track surfaces. I’m addition, i found it works well on crawlers. When applied to low hanging components, it reduces hang ups. It slides over sharp obstacles nicely. The only reason I say it’s “decent” is that when it’s time to remove it, the adhesive stays behind and is a pain in the a$& to get off. Minor issue compared with how it performs in my opinion.
took a chance on this chassis protector it really thick and it stick good. rock that i scraped on the bottom don't even get through it. the only bad thing you can't see through it. You should make a template of your chassis first then cut it out and after that you put on your chassis and then trim the rest with a X-Acto Knife.
Reviewers generally find this pink chassis protective sheet thick and durable, with one noting it resisted scrapes and impacts without breaking through and another comparing it favourably to thinner vinyl. It is described as sliding well over rough surfaces and reducing hang-ups on crawlers. Drawbacks mentioned include the material being opaque, so the chassis underneath cannot be seen, and adhesive residue that is difficult to remove when the sheet is taken off. One reviewer recommends making a template and trimming the sheet to fit with a hobby knife. Three reviews were available, so the picture is limited.
- + thick and durable material
- + resists scrapes and impacts
- + slides well over rough surfaces
- + reduces hang-ups on crawlers
- − opaque, cannot see chassis through it
- − adhesive residue hard to remove
- − requires careful trimming to fit