RadioMaster LiIo TX Battery (TX16S/TX12 MKII/MT12) (7.4V/5000mAh) w/XT30

Battery Overview:

The RadioMaster 5000mAh 2S Li-ion battery pack is an ideal choice for the TX16S radio, delivering extended run times and a safer alternative to LiPo batteries. Known for high energy density, this Li-ion pack suits lower current applications, providing convenience with TX16S’s internal charging capabilities. Perfect for hours of flight, it includes an XT30 output plug at an optimal length for external modules like the TBS Crossfire, ensuring seamless integration and worry-free power for your RC adventures.

Features:

• Designed for MT12, TX16S, and TX12 MKII transmitters
• Includes XT30 and JST-XH connectors

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.