RC4WD Axial SCX10 II Tough Armor Front Winch Bumper (Type A)
About this part
RC4WD Axial SCX10 II Tough Armor "Type A" Front Winch Bumper. This bumper is compatible with the RC4WD Warn 9.5 and 8274 winches, as well as the RC4WD Warn Hawse Fairleads (RC4ZS1310, RC4ZS1315).
Features:
- CNC Machined
- Hand Welded
- Billet Aluminum and Stainless Steel
- Black Powder-coated Finish
- Manufactured by RC4WD
Total Length: 5.51in / 140.0mm
Total Width: 2.56in / 65.08mm
Total Height: 3.06in / 77.72mm
Total Weight: 4.13oz / 217.0g
Reviews1.3 · 4 reviews
I bought one of these bumpers for my scx10ii trail honcho expecting to get a well put together metal bumper but what i got wasnt that at all what i got was a bumper that didnt even hold up to 10 minutes of driving with a insanley slow rc4wd 35t on a 2s lipo barely above storage charge it probably wasnt going 2mph when the microscopic welds holding the stinger broke after the small sheet metal supports on the stinger bent like a peice of hot plastic. if your actualy gonna crawl i wouldn't buy this
Had better luck than the other reviewers,my stinger broke off after several runs from a hard rollover. Problem is the base is aluminium and the stinger bar is steel, a small steel pin is pressed into the base and the bar is spot welded it. Not enough material.
Absolutely garbage,, this bumper lasted 10 minutes until it broke. Yes it looks good but the front guard snapped off after one light hit during a crawl. DO NOT BUY THIS BUMPER!!!
stinger broke off on the very first run and was super gentle with my rig, after looking at it it was held on by what i would not even call a tack weld. Really disappointed with rc4wd QC.
All four reviews are negative and describe the same recurring problem: the stinger (the protruding bar on the bumper) breaks off or fails after limited use, in some cases within minutes and during gentle driving or light impacts. Reviewers attribute this to weak attachment, with one describing the stinger as held by spot welds and a small pin pressed into an aluminium base, and another noting the stinger bar is steel while the base is aluminium. One reviewer also reports sheet metal supports bending. Reviewers agree the bumper looks good but do not hold up to use. Two reviewers are verified owners; all reviews refer to this same bumper variant, Type A.
- + Looks good
- − Stinger breaks off or fails quickly
- − Weak welds or attachment
- − Supports bend under light use
- − Concerns about quality control