RPM Losi Mini-T 2.0/Mini-B Heavy Duty Front A-Arms (Black)
About this part
- The front inner hinge pin boss is roughly 25% thicker than stock (and dramatically thicker than first gen Losi A-arms)
- RPM has increased the overall thickness of the A-arm by roughly another 25%.
- Support beams are consistent on thickness and are roughly 50% thicker than some of the thinner supports of stock Losi A-arms.
- Beefier A-arm support beams provide better shock pivot protection. This means the A-arm will be the 1st to strike debris instead of the shock pivot ball.
Reviews5.0 · 4 reviews
Significantly improved longevity and stiffness compared to the original arms. Yes these are twice the price, but they last much longer and have noticeably less slop over the long run. Keep in mind if you do run these arms with T-Bone bumpers, they will rub around the hinge pins unless you trim the bumper.
Stronger and better look than stock arms...great upgrade !
holding up great! paired with the rpm bumper! would buy again
Much stronger than standard arms rear arm set needed trimming this did not
All four reviewers rate these front A-arms 5/5 and report they are stronger and more durable than the stock arms, with one noting reduced slop over time and a better look. Reviewers acknowledge the higher price, with one saying they cost roughly twice as much as the originals. One reviewer reports the arms rub around the hinge pins when used with T-Bone bumpers unless the bumper is trimmed. Another reports a rear arm set needed trimming, though the comment is brief and unclear on whether it refers to these front arms. Reviews are few and short, so the picture is limited.
- + Stronger than stock arms
- + Longer lasting
- + Less slop over time
- + Better appearance
- − Roughly twice the price of stock arms
- − Rubs around hinge pins with T-Bone bumpers unless trimmed
- − Rear arm set reportedly needed trimming