Savox SB-2264MG Low Profile Digital "High Speed" Brushless Metal Gear Servo (High Voltage)

I used this low profile servo in a Tekno EB410. I used it at one night of practice and it stripped itself out. The servo before destruction worked well, however I thought it would take more abuse. 2 stars for being a nice piece but minus 3 for not lasting very long for a METAL GEAR SERVO. UPDATE....I replaced this servo with a PROTEK PTK-160T. I highly recommend this servo over this particular SAVOX. The protek weighs ~6 grams less and comes with an aluminum servo horn. I had purchased it separately in the beginning and the price is basically the same in doing so. If you have a choice and what a better quality piece go with the protek.

very cheap. bought this servo lasted a few batteries. when first installed to my eb48sl it seemed like a gear was stripped but problem went away when I put a metal servo horn on(would not return to center after turning and would not turn all the way back the other way). has a water proof seal on top and bottom so should be water proof. servo wire is to short so there is another $5 or void your warnty. the servo stop is just a plastic piece inside unlike other servos that have a plastic stop along with at the bottom of a gear there is a rod that will hit the end points. the plastic stopper is what broke in my servo it seems as there was nothing to keep the servo from turning further then it should(when i had problems with the servo it did not have strength to turn the wheels anymore). this servo can not be taken apart easily to get at the board and try and fix it. as far as i can see you can not take the board out without breaking it. all the gears are metal and it has rubber seals on both sides of the case but is not water proof. would not buy savox again with there crap support and a brand new servo dying after a few batteries. spend the extra $40 on a nice protek servo so you dont have to spend another $100-150 on a new servo in a week. also the plastic servo horn i had seemed to rub off some of the metal housing on top what seems like very cheap and weak metal.

Pure garbage! Do not buy. I wish I read the reviews before buying. This servo only lasted around 5 minutes or so under normal use. No crash or binding. End points were set properly and gears just let go. A-main will not warranty even though it's still in the time limit, so I'm out over 100 dollars for a useless hunk of aluminum.

MALO NO LO RECOMIENDO, SE GOLPEO ALGU SUAVE EL AUTO Y EL SERVO DEJO DE FUNCIONAR.

First of all, shame on me for not looking at the reviews prior to purchasing this servo. I have been running Savox mid to upper level servos exclusively for many years and have never had an issue. This servo however, and I bought 2 of them prior to the first install and failure, is not up their standard and I am guessing they know it. I installed the first one in my 22X4 and it made it for less than 2 practice packs on a glued clay track. No crashes and I assumed it was just a uniquely bad servo. I installed the second one at that point and made it through 2 more practice packs, one full heat, and half of the next before the same gear stripped. That was $220 absolutely wasted and I cannot say anything but shame on you Savox. With all of the good luck I have had previously, I am going to give them a chance to respond to my emails and make it right. So far however, no response either by phone or email. This servo does not even deserve one star!