Scale By Chris Large ProTek 3D Printed Charger Stand (180mm Wide)
About this part
The Scale by Chris Large ProTek Charger Stand is an incredibly useful accessory developed specifically for the ProTek RC 610 Quad and 625 Duo chargers. This stand will improve functionality and ease of use by raising up the the back of the charger, making it easier to view the screens and access the buttons. The five piece design features two angled side plates, with two rear cross braces and a front plate with SBC logo, and its all held in place with included stainless steel hardware. The stand measures in at approximately 180mm wide, and 180mm long, so it will fit any charger with a footprint larger than 180x180mm. Plus, you can use the area beneath the charger to keep extra charge leads easily accessible, as well as to stash the power cable out of the way.
Scale by Chris products are designed and printed in the USA. Nothing with the SBC name is ever outsourced, meaning Chris puts his hands on every part before it goes out the door. All this effort is done to create a higher quality finished product, with the functionality you need to take your work space to the next level.
NOTE: If the stand slides on your work surface, you can add electrical tape, adhesive rubber dots, or an adhesive foam strip to bottom of the base on each side to create grip.
Reviews3.8 · 4 reviews
Bought 2 sets. Both sets came with only 6 of 8 screws. 2 screws short to assemble the set. Finishing is rough, no where as nice as in the photos. Had the impression that is it metal but it is actually cheap 3D printed plastic parts.
Great stand for protek quad charger. Makes it nice to use when charging batteries.
I’m using mine with the Protek Prodigy 625 and it serves it purpose. I’m looking forward to seeing how long it holds up as I will definitely transition to a more durable version when the time comes.
Fits my HiTec Power Peak D7 perfectly. The angle and height are great. I look forward to using it for a long time.
Reviewers describe the 180mm wide 3D printed charger stand as a practical, low-cost stand for charging batteries. Two reviewers praise its fit and convenience with ProTek and HiTec chargers, with one a 4/5 rating expecting it may need replacing later for durability. Recurring criticisms come from a single buyer who bought two sets: both arrived missing two of eight screws, the finish was rougher than the photos suggested, and the parts are plastic rather than metal as they had assumed. Overall, reviews are mixed and the sample is small.
- + Fits chargers well
- + Convenient for charging batteries
- + Good angle and height
- − Missing screws in delivered sets
- − Rough finish versus photos
- − Plastic rather than metal construction
- − Durability uncertain