SH Engines .18 Pull Start Rear Parts Set

This fits a Dynamite Mach 2 .19T PERFECTLY, as it is much better than the revised backplate Dynamite uses on the 19 (revised still may chew up backplate bushings... u can mod an ez start system to work with this I've seen it done but SHETS1A-3 works perfectly if u want to use a pull start [and it is a fine one too])

This fit my old SH/Megatech M16/Sh .16 perfectly to replace the old worn out starter system. I did end up using the old back plate screws because the new ones were a little tight but that may be due a little grime build up in the holes over the last ~18 years.