SH Engines
SH Engines .18 Wrist Pin Clip (2)
Part # SHETE1207A5.0(1)
Where to buy
$1.29
Prices are as last seen at the store; stock is not tracked.
About this part
This is a pack of two replacement SH Engines .18 Wrist Pin Clips. The wrist pin (piston pin) is installed through the piston and into the upper rod bushing and connects the rod to the piston. When you remove the wrist pin, it is recommended that you install new wrist pin clips to prevent possible failure caused by using used clips.
Reviews5.0 · 1 review
Clark HudnallVerified owneron SH Engines .18 Wrist Pin Clip (2)
These little piston pin retainer clips do the job well! They are priced right! However they are a pain to put in being so small and like to fly across the room where you will never find them again but they are so cheap I ordered several sets just in case! I have used these so far in both a SH.18 and also a old Hpi engine I rebuilt as well!
Builds using this part
No builds use this part yet — add it to yours from the build editor.