SSD RC Scale Steel Long Rear Driveshaft for Traxxas TRX-4/SCX10 II
About this part
SSD TRX-4 / SCX10 II Scale Steel Long Rear Driveshaft.
Features:
- CNC Machined
- Hardened Steel
- Scale design
- Fully assembled
- Precision splines
- Up to 50 degrees operating angle
- Includes M4 screw pins (SSD00237)
- Compatible with Axial M4 scew shaft (AX31045)
- Suitable for rear of 324mm wheelbase Traxxas TRX-4 (Land Rover D110, Tactical)
- Suitable for rear of 313mm wheelbase Axial SCX10 II kit version with 2 speed transmission
- Fits 5mm diameter shafts
- M4 set screw
Specifications:
Min length (pin to pin): 116mm
Max length (pin to pin): 140mm
Includes:
- (1) Long Steel Driveshaft
- (2) M4 Driveshaft pins
- For rear of 312mm wheelbase TRX-4 use (SSD00089)
- Short front driveshaft is also available (SSD00255)
Reviews4.3 · 3 reviews
Just another outstanding product by s s d this is one very Stout driveshaft if you break it you must have had it under a real car
I have been running these for 2 plus years. I have had on problems with them! Very scale looking. I run one on my old Yeti and still going! I would recommend them for crawlers for sure!
Bought this driveshaft 1st of march, and its game over. the pins that holds the hinge joint or whatever its called together is just finished, its just not there any more :/
Three reviews of the SSD RC Scale Steel Long Rear Driveshaft for the TRX-4 and SCX10 II, all listed under this variant. Two reviewers rate it 5/5 and describe it as durable and scale-looking, with one reporting over two years of use without problems, including on an older Yeti. The third reviewer, a verified owner rating it 3/5, reports the pins securing the hinge joint wore out or disappeared soon after purchase. The reviews agree on strength and appearance but disagree on durability, and the sample is small.
- + Strong, durable steel construction
- + Scale appearance
- + Long service life reported by one owner
- − Hinge joint pins reported to fail early in one review