SSD RC SCX10 Pro & III Straight Axle Heavy Brass Steering Knuckles (2)
About this part
SSD SCX10 Pro and III With Straight Axle Heavy Brass Steering Knuckles. Constructed from quality CNC-machined brass, these optional brass steering knuckles are intended for the Axial SCX10 Pro and III with straight axles to add unsprung weight and lower the Center of Gravity where its needed most to enhance crawling performance and durability.
Features:
- CNC machined brass
- Anodized Gun Metal
- Fits stock Axial SCX10 Pro and III with straight axles.
- Adds 82g (each knuckle)
- (2) Brass Knuckles
- (4) Brass Bushing
- (4) M3 x 10mm screws
- (1) M3 x 14mm screw
- (1) M3 x 20mm screw
CA Residents Prop 65 Warning
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...Reviews5.0 · 3 reviews
I was trying to find some brass knuckles for my new SCX10 Pro and someone on line said these fir the Pro so I gave them a try and I can say These are a direct fit to the SCX10 PRO!
Finish and weight are really nice. One bearing pocket was a little tight. Overall a nice upgrade!
Adds great weight very high quality. Fit on truck and for bearings were perfect. Tightens up some of the slop the plastic knuckles get over time.
Three verified owners rated these brass steering knuckles 5 out of 5 and reported that they fit the SCX10 Pro. Reviewers praise the finish, added weight and build quality, and one says they reduce play that develops in the stock plastic knuckles over time. Bearing fit is described as good, though one reviewer found a single bearing pocket slightly tight. No recurring problems are reported. The review set is small, so the picture is limited.
- + Direct fit on SCX10 Pro
- + Good finish and build quality
- + Added weight
- + Reduces slop compared with plastic knuckles
- − One bearing pocket slightly tight