Team Associated RC8B3.2/T3.2 Factory Team HD Gearbox
About this part
- The diff will need to be adjusted from the stock ASC81015 gearbox. Recommended to start with one thin (0.1mm, the thinnest available) on each side.
- To fine tune the suspension arm shimming on the inner hinge pin, use 0.9 or 1.0 caster adjustment shims from the ASC81446 RC8B3.2 Shim Set, and you can trim off the pull-tab for ground clearance.
CA Residents Prop 65 Warning
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...Reviews4.0 · 3 reviews
love the fact of having a stronger part but the treads are really soft and you cannot tighten the screws at all they will pull the threads right out it is possible I received a bad set but the old factory ones were put back on I just don't want to think ASSOCIATED has went down hill in their manufacturing
The material feels stronger and the screw feels way better going in .So far replaced only rear diff with this & the screws are NOT striped & feel great/tight..So i will DEFF buy this for front gearbox aswell (:
Better than originals. Very solid screw engagement.
Reviewers largely agree the gearbox part feels stronger than the originals, with two of three praising solid screw engagement and tight fit. One verified owner rated it 2/5, reporting that the threads felt soft and the screws stripped out when tightened, so the old factory parts were reinstalled. That reviewer suspected a bad batch rather than a design issue. The sample is small (three reviews), so the disagreement over thread quality cannot be resolved from these alone.
- + Stronger material than originals
- + Solid screw engagement
- + Screws tighten well
- − Soft threads on one unit
- − Screws stripped when tightened on one unit