Team Exalt "X-Rated" Shorty 2S 150C Lipo Battery (7.4V/4400mAh) w/5mm Connectors (ROAR Approved)

X Rated High Performance 2S LiPo Battery

This is the 2S 150C X-Rated Shorty LiPo Battery from Team Exalt. Get ready to dominate your races with the 4400mAh capacity and high-performance features of this cutting-edge Lipo battery. Team Exalt's X-Rated technology combines high voltage, low resistance, and a flat discharge curve, thanks to Silicon Graphene cells that enhance cycle life and efficiency.

About the X-Rated Shorty LiPo Battery

X-Rated Cells

The X-Rated cells featured in this Lipo battery are specifically engineered to deliver outstanding performance on the racetrack. Designed to combine high voltage, low resistance, and a flat discharge curve, these cells ensure consistent power delivery throughout your races. Whether you're accelerating out of corners or pushing for top speeds on the straights, the X-Rated technology provides the reliability and efficiency needed to stay competitive.

Silicone Graphene Technology

One standout feature of this battery is its Silicone Graphene technology, which sets it apart from standard Lipo batteries. This advanced technology enhances the battery's ability to handle high currents and endure tough racing conditions. The addition of Silicone Graphene stabilizes the cells, increasing their cycle life and efficiency. This means more races, more power, and less worry about battery performance.

5mm High-Amp Bullet Connectors

Ensuring a secure and efficient power transfer is crucial in competitive RC racing. The 2S 150C X-Rated Shorty Lipo Battery comes equipped with 5mm high-amp bullet connectors, which provide a reliable connection between the battery and your RC vehicle's electronic speed controller (ESC). These connectors are designed to handle high currents without overheating or losing efficiency, allowing you to unleash the full potential of your vehicle without concerns about power delivery.

Features:

• X-Rated cells are designed for high voltage, low resistance, and a flat discharge curve
• Silicone Graphene technology handles more abuse and delivers higher current
• Improved efficiency lowers operating temperatures and internal resistance
• 5mm High-Amp bullet connectors ensure secure and efficient power delivery
• ROAR approved with racing standards since November 2023

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.