Tekno RC Aluminum Single Sided Clamping Servo Horn (25T)
About this part
This is the Tekno RC Aluminum Single Sided Clamping Servo Horn for 25 tooth servo splines; such as Futaba, Savox and ProTek R/C.
This Tekno RC Aluminum Servo Horn is designed to minimize forces transmitted back to the servo spline. The horn utilizes a bottom mount design that, as opposed to a top mount, lowers the leverage point. This means your servo will be protected better to keep you in the race.
There are two mounting positions to fine tune your application. A hefty M3 locking screw ensures the servo horn will never come loose again. The M3 screw is also easy to tighten down compared to the smaller M2 screws that easily strip out on other servo horns. Use TKR1325 (M3x14mm flathead screw) for mounting the steering linkage to your Tekno RC vehicle. Use thread locking compound on all metal-to-metal connections.
Although this horn was designed specifically for the Tekno RC line of vehicles, it can also be used in most other applications.
Note: Tekno R/C strongly recommends using the inside (short) mounting hole for use in Tekno RC vehicles. This will make the steering response smoother and also protect your servo better.
Reviews5.0 · 6 reviews
Goes perfectly with my et48.3 and the Protek 170TBL servo. So much better than the stock plastic servo horn. This really should be included in the kit. Every Tekno kit I get from here on out will have one of these on the order...
perfect fit! this is a must for tekno 1/8 scale rigs
The countersink is the ticket, ready to send it again.
Must have Servo horn for Tekno vehicles the way the linkage is set up. Great quality too. Awesome.
Great servo, easy to install, work well. I like that it only requires one screw.
All six reviewers rate this aluminum single-sided clamping servo horn 5/5 and are verified owners of the 25T variant. Reviewers consistently describe it as a clear upgrade over the stock plastic horn, with an easy install that needs only one screw and a good fit with Tekno 1/8 scale vehicles and their linkage setup. Several mention pairing it with Protek servos and the EB48.3 or ET48.3. One reviewer notes the screw must be installed in the correct direction or the horn may not stay secure. No reviewer reports breakage or a negative experience.
- + Clear upgrade over stock plastic horn
- + Easy installation with one screw
- + Good fit for Tekno 1/8 scale vehicles
- + Holds securely and resists stripping
- − Screw must be installed in the correct direction