Traxxas Center Driveshaft Set (2)
About this part
Complete kit includes front and rear driveshafts, ready to install. Fits E-Revo, Summit, and E-Revo Brushless Edition.
Features:
- Heavy-duty construction for total torque transfer
- Fully assembled and ready to install
- U-joint pins are captured to prevent loosening and loss
- Beautiful plated and anodized finishes for a high-tech, high-performance look
- Factory-lubricated joints are sealed by rubber boots for long life and smooth operation
- Genuine Traxxas quality
Reviews3.0 · 3 reviews
Just finished installing these driveshafts. Very easy to install and are a perfect fit, obviously because its from traxxas. They look and feel very strong. Definitely recommend for any summit upgrade.
WARNING Does not fit E-revo 2.0 ! its too long by 5+mm
The U joint pins are too long, the red ring is supposed to slide over and keep them in place but that’s impossible. Tried to tighten them and they snapped off inside and had to dremmel the other end of the pin off so it will even spin. Still can’t get them off without destroying something.
Three reviews cover the Traxxas Center Driveshaft Set (2) with mixed results. One verified owner found installation easy, reporting a good fit on a Summit and a strong feel. Another reviewer reports the set is too long by over 5mm for an E-Revo 2.0, so it does not fit that model. A verified owner also reports the U-joint pins were too long, the retaining red ring would not seat, and tightening caused the pins to snap inside the joint, leaving the part difficult to remove. Fit appears to depend on the vehicle, and reviewers disagree on overall quality given the limited sample.
- + Easy installation
- + Good fit on Summit
- + Feels and looks strong
- − Too long for E-Revo 2.0
- − U-joint pins too long
- − Pins snap when tightened
- − Difficult to remove