Traxxas Stub Axle Pins (4)
About this part
Reviews5.0 · 4 reviews
These are the pins for any 1/10 scale Traxxas I got them to replace the ones I lost in my slash 4x4
I wish it included more pins, but its a traxxas product, it served its purpose quite well
Cheap easy replacement for the pins I lost! Got a couple packs to keep on hand.
This isn't a bad review, just a clarification on the other review. These do not fit the 1/10 Traxxas Trx-4 portal gear stub axles properly. I based my purchase off the review that said, "These will fit any 1/10 traxxas rc." When I purchased these, I didn't need the hubs from the Trx-4 pin set, so I tried these to save a couple bucks. Idk if they work on every other 1/10 Traxxas RC like the previous review stated. These are 10mm long and 2mm thick. Trx-4 portal pins are a bit longer. I did install them as a temporary replacement, but they are a bit short.
Four reviews, all rated 5/5 by verified owners. Most reviewers used these pins as replacements for lost stub axle pins on Traxxas models, including a Slash 4x4, and found them cheap and adequate. One reviewer wished the pack contained more pins. One review disputes the general fit claim: a Trx-4 portal gear owner reports these pins are about 10mm long and 2mm thick, which is shorter than Trx-4 portal pins, and that they fit only as a temporary replacement. The fit claim for all 1/10 Traxxas models is therefore not uniformly supported by these reviews.
- + Cheap replacement pins
- + Works as a stub axle pin replacement
- + Good value for keeping spares on hand
- − Pack contains only four pins
- − Too short for Trx-4 portal gear stub axles
- − Fit across all 1/10 Traxxas models not confirmed