Vanquish Products Aluminum Wraith/Yeti Clamping Lockout (2) (Black)
About this part
This is a pack of two optional Vanquish Black Anodized Aluminum Clamping Lockout, intended for use with the Axial Wraith and Yeti Rock Racers.
These lockouts are a direct bolt-on part for the Wraith and Yeti and provide additional clamping power with zero slop. They also provide great looks and matching anodize for any existing Vanquish parts on your rig.
Features:
- Direct replacement to for stock Axial Wraith and Axial Yeti Rear Lockouts
- Clamping for extra holding power and zero slop
- Works with Axial Racing OCP axles, including Ridgecrest
- Replaces AX80071, AX30789
- Also available in black anodize (VPS07671)
- Includes mounting hardware
Reviews5.0 · 2 reviews
used for my yeti and smt10, fitment is much tighter which makes it also harder to remove if you needed to service the axles. built with bashing in mind to support the axles and bearings better.
These solve one of the biggest design flaws of the AR60 housing. The clamping force relieves the stress placed on vertical screws holding the lockouts in place. This greatly reduces or even eliminates the chances of stripping out your axle housing from driving. My (very expensive) aluminum VP AR60 housings were stripped to the point that they were unusable, but these lockouts allow me to run them again. Another benefit is the boss around the screws on the original design has been removed, allowing for lower profile and easier sliding over obstacles. Great job on these VP!!