Vanquish Products
Vanquish Products Brass Rear Axle Cap Weights (2) (52g)
Part # VPS040043.0(1)
Where to buy
$20.99
Prices are as last seen at the store; stock is not tracked.
About this part
The Vanquish Brass Rear Axle Cap Weights add 52 grams of non-rotating mass to the rear axle housing for adjusting weight distribution and lowering center of gravity.
Replaces the caps on the ends of the Vanquish Products axles listed below:
- VS4-10 D44 Rear Axle
- SCX10-II F9 Rear Axle (non-portal)
- SCX10-II RockJock Rear Axle
- VS4-10 F9 Rear Axle (non-portal)
CA Residents Prop 65 Warning
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov Details...Reviews3.0 · 1 review
Matthew TaylorVerified owneron Vanquish Products Brass Rear Axle Cap Weights (2) (52g)
I gave these 3 stars, because they are well made and very nice. However, they do not fit the Vanquish Phoenix VS4-10 kit. I am currently deciding on whether I want to modify my rear axle to make them fit. They are extremely tight, to where I cannot get them more than 3/16” onto the end of the axle, and they would need to have the molded in axle truss trimmed back about 1/8” to allow the bolt holes to line up.
1 found this helpful
Builds using this part
No builds use this part yet — add it to yours from the build editor.