RCFeed Logo
Builds FeedParts FeedRC MarketplaceDiscussAbout Us
Parts/Electric power/Motor parts/Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)
Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)
Yeah Racing

Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)

Part # YEA-YA-0569BK1.0(3)
Motor partsLandcraft
Where to buy
$16.25
AMain Hobbies
Seen Oct 12, 2026
$16.25Buy
Prices are as last seen at the store; stock is not tracked.

About this part

The Yeah Racing 1/8 Scale Motor Aluminum Fan Mount features a wire hiding clamp, where you can neatly tuck your fan wire underneath and can prevent it from catching onto moving parts! Fits both 30mm and 40mm fans, and a setscrew at the top allows you to tighten the clamp to prevent the mount from moving when you have set it to the desired angle.

Specifications:
For: 1/8 Motors
Material: Aluminum
Color: Black
Motor Diameter: 41mm

Reviews1.0 · 3 reviews

Jose Angel PortilloVerified owneron Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)

Good afternoon, I want to inform you that today I installed the support for the engine fan, but it wasn't tightened properly and it broke. I am letting you know in case the iron component is faulty. "I have the photo. Can you tell me if I should send it and where?"

Travis BrewerVerified owneron Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)

Doesn't fit 41mm motor hobbystar 4092. Too big, snapped right in half when tightening

Jonathan Jafarion Yeah Racing 1/8 Scale Motor Aluminum Fan Mount (Black)

Too big for a 41mm motor, snaps in half when tightening like other reviewer said.

What reviewers say

All three reviewers rate this aluminum motor fan mount 1 out of 5 and report that it broke while being tightened during installation. Two reviewers say it is too large for a 41mm motor, specifically a Hobbystar 4092. One reviewer suspects a faulty iron component, though the mount is aluminum in the listing, and asks where to send photo evidence of the failure; no reply is recorded. The reviews are consistent about breakage and fit, but the sample is small and the cause of the breakage is not confirmed.

  • − Breaks when tightened during installation
  • − Too large for a 41mm motor
  • − Reported fit problem with Hobbystar 4092
Summary generated from the reviews above.

Builds using this part

No builds use this part yet — add it to yours from the build editor.